[Strip One >>>>>][Strip Two>>>>>>>>>>][Strip Three>>>>>>>>>][Strip 4>>>>>>]
Pipe..............Strip 1 wire inside pipe....Strip 1&2 inside.....1,2,3 inside...
Then at the very end you would 4 sets of wires for that gutter going to the controller. All wires hidden onto the end and then down to the porch.
Notice the "Wall Tie" ("Wall Ties" are explained below) and how it is looped around. It is in between the 2 LED's so as not to block the light. Then it goes up over the gutter. I took my hand (with a gloove on for protection...remember it is sharp!) and gripped the side with the pipe and then gripped the backside so as to grip the gutter. This made for a tight fit that held up REAL well for several weeks. I honestly think it could have stayed up forever.
Not notice the slotted coupling. Notice that it is just small enough for the strip to go between. I tried spacing these so the LED spacing was just like it was on the strip. Hopefully that would help with gaps.